Removed the wipers and stripped the trim off to get to the wiper motor. Checked motor all appeared in order and loom seemed ok. Checked the pins for voltage while operating the wipers. All seemed in order and power at pin 2. Squirted some electrical cleaner into DIN plug and connector on the wiper motor.
Check windshield washer fluid. First, you should check whether there is enough windshield washer fluid in the reservoir of your vehicle. Fill the container with a suitable mixture of detergent and water that is as soft as possible. Collected and filtered rainwater is optimal because it contains few mineral components compared to normal tap water. Easy. Take the pipe that leads to the jets, just underneath the bonnet. check for a blockage, as crap from lack of use may have solidified over time. pin prick the jets. if the water is coming out of the pipes, your good to go. Focus Fixer. November 2009. If you came here assuming that the back reservoir is empty (again, there isn’t one) because it isn’t working, then you might have an issue with a clogged tube or spray nozzle. This isn’t a typical experience unless you’re using dirty fluid or water, the latter of which can freeze. Nozzles can, of course, have debris fall on them so you
HI, I have a ford fiesta 2011 and my windshield washer is only working on rear wind screen. I replaced the pump but still with the same problem. There is 12v on the pump connector when pressing the button. It works on the rear but front completely dead including wipers. When I remove the pump the wipers start working.
Eric Bloodaxe. FOC Supporters. 6.9k. Name: Roger. Ford Model: Fiesta Mk 8.5 ST-3 5 door. Ford Year: 2023. UK/Ireland Location: Yorkshire. Posted January 2, 2020. My screen never seems to come on twice in the same way - sometimes I get the Ford logo first, sometimes not, sometimes it comes on as soon as the car is unlocksd, sometimes when the
. 2852351501081362219319249
